Product Name: (6S)-2,6-diamino-4,5,6,7-tetrahydrobenzothiazole tartrate trihydrate
Chemical Formula: C9H14N4O6S
Other Names: None commonly used
Recommended Use: Laboratory reagent, chemical synthesis intermediate
Supplier: Contact local distributor or manufacturer
Emergency Contact: Local emergency services or poison center
CAS Number: Not widely registered; specific to specialty chemicals
Restrictions: Intended for professional laboratory or industrial use only; not for food, drug, or household use
Classification: May cause skin and respiratory irritation; not classified as a carcinogen
Signal Word: Warning
Hazard Statements: Causes mild skin and eye irritation, possible allergic skin reaction
Symptoms of Exposure: Coughing, itching, redness, mild headache if inhaled
Pictograms: Exclamation mark (Irritant)
Precautionary Statements: Wash hands thoroughly after handling, wear gloves, avoid dust formation, use in well-ventilated area, avoid ingestion, do not eat, drink, or smoke when using this product
Routes of Entry: Skin, eyes, inhalation
Chemical Name: (6S)-2,6-diamino-4,5,6,7-tetrahydrobenzothiazole tartrate trihydrate
Synonyms: No other significant synonyms
Concentration: 95%-100% active ingredient
Impurities: None expected above 1% w/w; residual solvents below 0.01% w/w
Hazardous Components: None listed under current OSHA or REACH, but standard chemical hygiene applies
Inhalation: Move to fresh air, seek medical attention if symptoms persist, offer oxygen if breathing becomes difficult
Skin Contact: Wash with plenty of soap and water for at least 15 minutes, remove contaminated clothing, seek medical advice for irritation or allergic reaction
Eye Contact: Rinse cautiously with water for at least 15 minutes, lift eyelids occasionally, seek medical care if discomfort continues
Ingestion: Rinse mouth thoroughly with water, do not induce vomiting unless directed by medical personnel, seek immediate health professional assistance
Most Important Symptoms and Effects: Redness, itching, mild respiratory irritation, possible nausea after swallowing
Notes for Medical Personnel: Treat symptomatically, no specific antidote known
Suitable Extinguishing Media: Dry chemical powder, foam, CO2, water spray
Specific Hazards: May release oxides of carbon, nitrogen, and sulfur under combustion
Protective Equipment: Use full protective gear with self-contained breathing apparatus
Fire-Fighting Instructions: Contain run-off, avoid inhalation of fumes
Flash Point: Not established; treat as combustible solid
Explosion Limits: Not applicable for standard concentrations
Thermal Decomposition: Can produce hazardous fumes above 200°C
Personal Precautions: Wear chemical-resistant gloves, goggles, lab coat, and dust mask or respirator
Environmental Precautions: Avoid release to waterways, soil, and drains
Containment: Sweep up with suitable absorbent material, place in closed container for disposal
Cleanup Procedures: Ventilate area, wipe surfaces with damp disposable towels, decontaminate tools and equipment
Disposal Considerations: Dispose waste according to local, state, and federal regulations
Decontamination: Wash area with diluted household bleach or soap and water for final clean-up
Handling: Use personal protective equipment, avoid contact with skin and eyes, prevent dust accumulation, operate in fume hood or locally ventilated space
Hygiene Measures: Wash hands thoroughly after each use, do not eat or drink while handling
Storage Conditions: Store at room temperature, keep tightly closed in original packaging, protect from light and moisture, keep away from incompatible materials such as strong oxidizers
Incompatibilities: Strong acids, bases, oxidizing agents
Storage Class: Chemical storage (non-flammable, non-corrosive solids); keep locked away from unauthorized access
Occupational Exposure Limits: None established specifically for this substance
Engineering Controls: Work inside fume hood or apply local exhaust ventilation
Personal Protective Equipment: Nitrile or neoprene gloves, safety goggles, lab coat, approved particulate respirator (P2 or N95) if airborne dust possible
Environmental Controls: Prevent spillage into drains, apply waste recovery procedures
General Protection: No contact lenses in use, work shoes reserved for chemical area, keep work area tidy to avoid accidental spills
Appearance: White to off-white crystalline powder
Odor: Odorless
pH: 4.2-5.8 (1% aqueous solution)
Melting Point: 143-153°C (decomposes above this range)
Boiling Point: Decomposes before boiling
Vapor Pressure: Not measurable at 20°C
Solubility: Soluble in water (10-20 mg/mL), negligible in most organic solvents
Density: 1.49-1.52 g/cm³
Partition Coefficient: Not determined
Autoignition Temperature: Not determined
Evaporation Rate: Not applicable for solid
Stability: Stable under standard temperatures and pressures for at least 2 years in closed packaging
Reactivity: Not known to react violently with common laboratory reagents
Hazardous Reactions: Avoid strong oxidizing or reducing conditions
Conditions to Avoid: Excessive heat, direct sunlight, humidity, strong acids and bases
Decomposition Products: Carbon dioxide, carbon monoxide, nitrogen oxides, sulfur oxides, organic vapors
Polymerization: Not expected under normal conditions
Acute Toxicity: Low oral and dermal toxicity predicted from structure; no rodent LD50 found in available literature
Skin Corrosion/Irritation: Causes mild irritation, not classified as corrosive
Eye Damage/Irritation: Causes slight to moderate irritation on direct exposure
Respiratory Sensitization: Possible mild respiratory tract irritation
Skin Sensitization: Allergic response possible in predisposed individuals
Germ Cell Mutagenicity: No data available on mutagenicity or carcinogenicity
Reproductive Toxicity: No reported reproductive or developmental risks in available studies
Chronic Effects: Repeated long-term exposure data lacking; best practice is to minimize all exposures
Ecotoxicity: Product not thoroughly studied; not expected to produce acute aquatic toxicity based on structural analogy
Persistence and Degradability: Organic structure may degrade slowly in environment; persistence not established
Bioaccumulative Potential: Not expected to bioaccumulate due to high water solubility
Mobility in Soil: High water solubility predicts moderate mobility
Other Effects: Prevent direct release to environment; avoid entering groundwater and public water systems
Waste Treatment Methods: Treat as chemical waste, incinerate in approved facility or dispose in accordance with national and local regulations
Packaging Disposal: Triple-rinse bottles, deface labels, discard as hazardous chemical packaging
Water Disposal: Do not flush to sewage, surface water, or storm drains
Community Disposal: Submit to licensed disposal operators; small laboratory quantities may go through authorized hazardous waste program
Reuse and Recycling: Not recommended due to potential contamination risks
UN Number: Not classified as dangerous goods by UN regulations
Proper Shipping Name: Laboratory Chemicals, n.o.s.
Transport Hazard Class: Not classified
Packing Group: Not assigned
Special Precautions: Avoid rough handling, transport in tightly sealed and correctly labeled containers
Marine Pollutant: Not listed
Inland Regulations: Check for local restrictions on chemical transport
Imported/Exported Quantities: Comply with customs and import controls for specialty chemicals
Global Inventories: Not listed on DSL, TSCA, or EINECS databases; likely regulated as novel research chemical
Labeling Requirements: Laboratory chemical; use hazard pictograms and precaution statements
OSHA Status: Not specifically regulated
WHMIS Classification (Canada): Not classified
REACH Registration: Not registered as of date of this sheet
SARA Title III Sections 302/304/313: Not listed
Right to Know Laws: Not listed by California Proposition 65, Massachusetts, or New Jersey as a hazardous substance
Other Requirements: Handle and dispose using best practices for non-listed but potentially hazardous research chemicals; proper recordkeeping and worker education recommended